What is considered the primary advantage of running BFD? A. reduction in time needed to detect Layer 3 routing neighbor failures B. reduction in CPU needed to detect Layer 3 routing neighbor failures C. reduction in time needed to detect Layer 2 switched neighbor failures D. reduction in CPU needed to detect Layer 2 switch neighbor failures Correct Answer: A This question is in 300-410 exam For getting CCNP Enterprise Certificate
Please login or Register to submit your answer
Refer to the exhibit. AS 111 must not be used as a transit AS, but ISP-1 is getting ISP-2 routes from AS 111. Which configuration stops Customer AS from being used as a transit path on ISP-1?
Refer to the exhibit. A network administrator configured name resolution for IPv6 traffic to be allowed through an inbound access list. After the access list is applied to resolve the issue, name resolution still did not work. Which action does the network administrator take to resolve the name resolution problem?
Refer to the exhibit. An engineer applies a prefix-list filter that lters most of the network 10 prefixes instead of allowing them. Which action resolves the issue?
Refer to the exhibit. AS 111 must not be used as a transit AS, but ISP-1 is getting ISP-2 routes from AS 111. Which configuration stops Customer AS from being used as a transit path on ISP-1?
Refer to the exhibit. R6 should reach R1 via R5>R2>R1. Which action resolves the issue?
Refer to the exhibit. Packets arriving from source 209.165.200.215 must be sent with the precedence bit set to 1, and packets arriving from source
209.165.200.216 must be sent with the precedence bit set to 5. Which action resolves the issue?
Refer to the exhibit. An IP SLA was configured on router R1 that allows the default route to be modified in the event that Fa0/0 loses reachability with the router R3
Fa0/0 interface. The route has changed to flow through router R2.
Which debug command is used to troubleshoot this issue?
