CORRECT TEXT – Lab- CLI – Central Florida Widgets recently installed a new router in their office. Complete the network installation by performing the initial router configurations and configuring R1PV2 routing using the router command line interface (CLI) on the RC. Configure the router per the following requirements: Name of the router is R2 – Enable. secret password is cisco The password to access user EXEC mode using the console…

QuestionsCategory: 200-125CORRECT TEXT – Lab- CLI – Central Florida Widgets recently installed a new router in their office. Complete the network installation by performing the initial router configurations and configuring R1PV2 routing using the router command line interface (CLI) on the RC. Configure the router per the following requirements: Name of the router is R2 – Enable. secret password is cisco The password to access user EXEC mode using the console…
Admin Staff asked 6 months ago
CORRECT TEXT -
Lab- CLI -
Central Florida Widgets recently installed a new router in their office. Complete the network installation by performing the initial router configurations and configuring R1PV2 routing using the router command line interface (CLI) on the RC.
Configure the router per the following requirements:
Name of the router is R2 -
Enable. secret password is cisco
The password to access user EXEC mode using the console is cisco2
The password to allow telnet access to the router is cisco3
IPV4 addresses mast be configured as follows:
Ethernet network 209.165.201.0/27 - router has fourth assignable host address in subnet
Serial network is 192.0.2.176/28 - router has last assignable host address in the subnet.
Interfaces should be enabled.
Router protocol is RIPV2 -
Attention:
In practical examinations, please note the following, the actual information will prevail.
1. Name or the router is xxx
2. EnablE. secret password is xxx
3. Password In access user EXEC mode using the console is xxx
4. The password to allow telnet access to the router is xxx
5. IP information
 Image
A.
B.
C.
D.
















 

Suggested Answer: Answer: Router>enable

Router#config terminal -
Router(config)#hostname R2 -
R2(config)#enable secret Cisco 1
R2(config)#line console 0 -
R2(config-line)#password Cisco 2
R2(config-line)#exit -
R2(config)#line vty 0 4 -
R2(config-line)#password Cisco 3
R2(config-line)#login -
R2(config-line)#exit -
R2(config)#interface faO/0 -
R2(config-if)#ip address 209.165.201.1 255.255.255.224 R2(config)#interface s0/0/0
R2(config-if)#ip address 192.0.2.176 255.255.255.240 R2(config-if)#no shutdown
R2(config-if)#exit -
R2(config)#router rip -
R2(config-router)#version 2 -
R2(config-router)#network 209.165.201.0
R2(config-router)#network 192.0.2.176
R2(config-router)#end -
R2#copy run start

This question is in CCNA 200-125 exam 
For getting CCNA Certificate


Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.

Next Post

Recommended

Welcome Back!

Login to your account below

Create New Account!

Fill the forms below to register

Retrieve your password

Please enter your username or email address to reset your password.