Refer to the exhibit. Which configuration must be applied to the router that configures PAT to translate all addresses in VLAN 200 while allowing devices on VLAN
100 to use their own IP addresses?

A. Router1(config)#access-list 99 permit 192.168.100.32 0.0.0.31 Router1(config)#ip nat inside source list 99 interface gi1/0/0 overload Router1(config)#interface gi2/0/1.200 Router1(config)#ip nat inside Router1(config)#interface gi1/0/0 Router1(config)#ip nat outside

B. Router1(config)#access-list 99 permit 192.168.100.0 0.0.0.255 Router1(config)#ip nat inside source list 99 interface gi1/0/0 overload Router1(config)#interface gi2/0/1.200 Router1(config)#ip nat inside Router1(config)#interface gi1/0/0 Router1(config)#ip nat outside

C. Router1(config)#access-list 99 permit 209.165.201.2 255.255.255.255 Router1(config)#ip nat inside source list 99 interface gi1/0/0 overload Router1(config)#interface gi2/0/1.200 Router1(config)#ip nat inside Router1(config)#interface gi1/0/0 Router1(config)#ip nat outside

D. Router1(config)#access- list 99 permit 209.165.201.2 0.0.0.0 Router1(config)#ip nat inside source list 99 interface gi1/0/0 overload Router1(config)#interface gi2/0/1.200 Router1(config)#ip nat inside Router1(config)#interface gi1/0/0 Router1(config)#ip nat outside








 

Suggested Answer: A

Community Answer: A



This question is in 200-301 Cisco Certified Network Associate (CCNA) Exam
For getting Cisco Certified Network Associate (CCNA) Certificate





Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.
The website does not contain actual questions and answers from Cisco's Certification Exam.