Instructions -
To configure a switch click on the console host icon in the topology.
You can click on the buttons to view the different windows.
Each of the windows can be minimized by clicking on the [-]. You can also reposition a window by dragging it by the title bar.
Most commands that use the "Control" or "Escape" keys are not supported and are not necessary to complete this simulation. The help command does not display all commands of the help system.
Scenario -
You work for SWITCH.com. They have just added a new switch (SwitchB) to the existing network as shown in the topology diagram.
RouterA is currently configured correctly and is providing the routing function for devices on SwitchA and SwitchB. SwitchA is currently configured correctly, but will need to be modified to support the addition of SwitchB. SwitchB has a minimal configuration. You have been tasked with competing the needed configuring of
SwitchA and SwitchB. SwitchA and SwitchB use cisco as the enable password.
All commands must be entered at the physical interface level.
Configuration Requirement for SwitchA:
✑ The VTP and STP configuration modes on SwitchA should not be modified.
✑ SwitchA needs to be the root switch for vlans 11, 12, 13, 21, 22, and 23. All other vlans should be left are their default values.
Configuration Requirement for SwitchB:
✑ Vlan 21
- Name:  Marketing
- will support wo servers attached to fa0/9 and fa0/10
✑ Vlan 22
- Name:  Sales
- will support two servers attached to fa0/13 and fa0/14
✑ Vlan 23
- Name:  Engineering
- will support two servers attached to fa0/15 and fa0/16
✑ Access ports that connect to server should transition immediately to forwarding state upon detecting the connection of a device.
✑ SwitchB VTP mode needs to be the same as SwitchA.
✑ SwitchB must operate in the same spanning tree mode as SwitchA.
✑ No routing is to be configured on SwitchB
✑ Only the SVl Vlan 1 is to be configured and it is to use address 192.168.1.11/24
Inter-switch Connectivity Configuration Requirements
✑ For operational and security reasons trunking should be unconditional and Vlans 1, 21, 22, and 23 should tagged when traversing the trunk link.
✑ The two trunks between SwitchA and SwitchB need to be configured in a mode that allows for the maximum use of their bandwidth for all vlans. This mode should be done with a non-proprietary protocol, with SwitchA controlling activation.
✑ Propagation of unnecessary broadcasts should be limited using manual pruning on this trunk link.
Topology -
 
Refer to the exhibit.
 
Which configuration ensures that the Cisco Discovery Protocol packet update frequency sent from DSW1 to ALS1 is half of the default value?

A. DSW1(config)#cdp timer 90

B. DSW1(config-if)#cdp holdtime 60

C. DSW1(config)#cdp timer 30

D. DSW1(config)#cdp holdtime 90

E. DSW1(config-if)#cdp holdtime 30

F. DSW1(config-if)#cdp timer 60




 

Suggested Answer: C



This question is in 300-115 Implementing Cisco IP Switched Networks (SWITCH) Exam
For getting Cisco Certified Network Professional (CCNP) Routing and Switching Certificate





Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.
The website does not contain actual questions and answers from Cisco's Certification Exam.