You have been asked to install and configure a new switch in a customer network. Use the console access to the existing and new switches to configure and verify correct device configuration. Refer to the configuration. For which configured VLAN are untagged frames sent over trunk between SW1 and SW2?

Questions › Category: 300-115 › You have been asked to install and configure a new switch in a customer network. Use the console access to the existing and new switches to configure and verify correct device configuration. Refer to the configuration. For which configured VLAN are untagged frames sent over trunk between SW1 and SW2?

0 Vote Up Vote Down

Admin Staff asked 3 months ago

You have been asked to install and configure a new switch in a customer network. Use the console access to the existing and new switches to configure and verify correct device configuration.
 
 
 
 
 
Refer to the configuration. For which configured VLAN are untagged frames sent over trunk between SW1 and SW2?

A. VLAN1

B. VLAN 99

C. VLAN 999

D. VLAN 40

E. VLAN 50

F. VLAN 200

G. VLAN 300


 

Suggested Answer: B

The native VLAN is used for untagged frames sent along a trunk. By issuing the "show interface trunk" command on SW1 and SW2 we see the native VLAN is 99.
 <img src="https://www.examtopics.com/assets/media/exam-media/01585/n27553200006.jpg" alt="Reference Image" />
 <img src="https://www.examtopics.com/assets/media/exam-media/01585/n27553200004.jpg" alt="Reference Image" />

This question is in 300-115 Implementing Cisco IP Switched Networks (SWITCH) Exam
For getting Cisco Certified Network Professional (CCNP) Routing and Switching Certificate





Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.
The website does not contain actual questions and answers from Cisco's Certification Exam.