A network engineer must configure a Fibre Channel interface on the Cisco MDS 9000 Series Switch. The configuration must meet these requirements:
• The interface must be disabled when the bit errors threshold is exceeded.
• Buffer-to-buffer credits must be set to the maximum value.
• The interface must have full bandwidth allocated for its port group.
Which command set configures a Fibre Channel interface that meets these requirements?

A. interface fc1/1switchport bit-errorsswitchport fcrxbbcredit 220 mode Fxswitchport rate-mode dedicated

B. interface fc1/1switchport ignore bit-errorsswitchport fcrxbbcredit 255 mode Fxno switchport rate-mode

C. interface fc1/1no switchport ignore bit-errorsswitchport fcrxbbcredit 255 mode Fxswitchport rate-mode dedicated

D. interface fc1/1no switchport bit-errorsswitchport fcrxbbcredit 220 mode Fxno switchport rate-mode








 

Suggested Answer: A



This question is in 350-601 DCCOR exam 
For getting CCNP Data Center Certificate


Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.