A network operator working for a private outsourcing company with an employee id: 4261:72:778 needs to limit the malicious traffic on their network. Which configuration must the engineer use to implement URPF loose mode on the GigabitEthernet0/1 interface?

A. router(config)# interface gigabitethernet0/1 router(config-if)# ip address 192.168.200.1 255.255.255.0 router(config-if)# ip verify unicast source reachable-via any router(config-if)# ipv6 address 2001:DB8:1::1/96 router(config-if)# ipv6 verify unicast source reachable-via any

B. router(config)# interface gigabitethernet0/1 router(config-if)# ip address 192.168.200.1 255.255.255.0 router(config-if)# ip verify unicast source reachable-via rx router(config-if)# ipv6 address 2001:DB8:1::1/96 router(config-if)# ipv6 verify unicast source reachable-via rx

C. router(config)# interface gigabitethernet0/1 router(config if)# ip address 192.168.200.1 255.255.255.0 router(config-if)# ip verify unicast source reachable-via rx router(config-if)# ipv6 address 2001:DB8:1::1/96 router(config-if)# ipv6 verify unicast source reachable-via any

D. router(config)# interface gigabitethernet0/1 router(config-if)# ip address 192.168.200.1 255.255.255.0 router(config-if)# ip verify unicast source reachable-via any router(config-if)# ipv6 address 2001:DB8:1::1/96 router(config-if)# ipv6 verify unicast source reachable-via rx








 

Suggested Answer: A



This question is in 350-501 SPCOR exam 
For getting CCNP Service Provider Certificate


Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.