An administrator is integrating a Cisco Unity Express module to a Cisco UCME system. A test call is placed to the Cisco Unity Express pilot number, but the administrator receives a busy signal. The dial-peer is configured as follows: dial-peer voice 4100 voip destination-pattern 41.. session protocol sipv2 session target ipv4:10.1.10.1 dtmf-relay sip-notify no vad How is this issue resolved?

QuestionsCategory: 350-801An administrator is integrating a Cisco Unity Express module to a Cisco UCME system. A test call is placed to the Cisco Unity Express pilot number, but the administrator receives a busy signal. The dial-peer is configured as follows: dial-peer voice 4100 voip destination-pattern 41.. session protocol sipv2 session target ipv4:10.1.10.1 dtmf-relay sip-notify no vad How is this issue resolved?
Admin Staff asked 4 months ago
An administrator is integrating a Cisco Unity Express module to a Cisco UCME system. A test call is placed to the Cisco Unity Express pilot number, but the administrator receives a busy signal. The dial-peer is configured as follows: dial-peer voice 4100 voip destination-pattern 41.. session protocol sipv2 session target ipv4:10.1.10.1 dtmf-relay sip-notify no vad
How is this issue resolved?

A. The dial-peer needs to be reconfigured to support the G.711 voice codec.

B. The destination pattern needs to be changed to match the dialed number of 4100.

C. The dial-peer needs to be reconfigured to support vad.

D. The dial-peer needs to be reconfigured to support H.323 instead of SIP.








 

Suggested Answer: A



This question is in 350-801 CLCOR exam 
For getting CCNP Collaboration Certificate


Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.

Recommended

Welcome Back!

Login to your account below

Create New Account!

Fill the forms below to register

Retrieve your password

Please enter your username or email address to reset your password.