An organization decides to implement NetFlow on its network to monitor the fluctuation of traffic that is disrupting core services. After reviewing the output of
NetFlow, the network engineer is unable to see OUT traffic on the interfaces. What can you determine based on this information?

A. Cisco Express Forwarding has not been configured globally.

B. NetFlow output has been filtered by default.

C. Flow Export version 9 is in use.

D. The command ip flow-capture fragment-offset has been enabled.








 

Suggested Answer: A

We came across a recent issue where a user setup a router for
NetFlow -
export but was unable to see the OUT traffic for the interfaces in NetFlow Analyzer. Every
NetFlow configuration aspect was checked and nothing incorrect was found. That is when we noticed the "˜no ip cef' command on the router.
CEF -
was enabled at
the global level and within seconds,
NetFlow Analyzer -
started showing OUT traffic for the interfaces. This is why this topic is about Cisco Express Forwarding.
What is switching?
A Router must make decisions about where to forward the packets passing through. This decision-making process is called "switching". Switching is what a router does when it makes the following decisions:
1. Whether to forward or not forward the packets after checking that the destination for the packet is reachable.
2. If the destination is reachable, what is the next hop of the router and which interface will the router use to get to that destination.
What is CEF?
CEF is one of the available switching options for Cisco routers. Based on the routing table, CEF creates its own table, called the Forwarding Information Base
(FIB). The FIB is organized differently than the routing table and CEF uses the FIB to decide which interface to send traffic from. CEF offers the following benefits:
1. Better performance than fast-switching (the default) and takes less CPU to perform the same task.
2. When enabled, allows for advanced features like NBAR
3. Overall, CEF can switch traffic faster than route-caching using fast-switching
How to enable CEF?
CEF is disabled by default on all routers except the 7xxx series routers. Enabling and Disabling CEF is easy. To enable CEF, go into global configuration mode and enter the CEF command. config t
Router#
ip cef
Router(config)#
Router(config)#
To disable CEF, simply use the "˜no' form of the command, ie. "˜no ip cef"˜.
Why CEF Needed when enabling NetFlow?
CEF is a prerequisite to enable NetFlow on the router interfaces. CEF decides through which interface traffic is exiting the router. Any NetFlow analyzer product will calculate the OUT traffic for an interface based on the Destination Interface value present in the NetFlow packets exported from the router. If the CEF is disabled on the router, the NetFlow packets exported from the router will have "Destination interface" as "null" and this leads NetFlow Analyzer to show no OUT traffic for the interfaces. Without enabling the CEF on the router, the NetFlow packets did not mark the destination interfaces and so NetFlow Analyzer was not able to show the OUT traffic for the interfaces.
Reference:
https://blogs.manageengine.com/network-2/netflowanalyzer/2010/05/19/need-for-cef-in-netflow-data-export.html

This question is in 300-101 Cisco Implementing Cisco IP Routing (ROUTE) Exam
For getting Cisco Certified Network Professional (CCNP) Routing and Switching Certificate




Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.
The website does not contain actual questions and answers from Cisco's Certification Exam.