For More Information about simulation visit : www.examtut.com
A network associate is adding security to the configuration of the Corp1 router. The user on host C should be able to use a web browser to access financial information from the Finance Web Server. No other hosts from the LAN nor the Core should be able to use a web browser to access this server. Since there are multiple resources for the corporation at this location including other resources on the Finance Web Server, all other traffic should be allowed.
The task is to create and apply a numbered access-list with no more than three statements that will allow ONLY host C web access to the Finance Web Server.
No other hosts will have web access to the Finance Web Server. All other traffic is permitted.
 
Access to the Router CLI can be gained by clicking on the appropriate host.
All passwords have been temporarily set to "cisco".
The Core connection uses an IP address of 198.18.196.65
The computers in the Hosts LAN have been assigned addresses of 192.168.33.1  192.168.33.254
Host A 192.168.33.1 -
Host B 192.168.33.2 -
Host C 192.168.33.3 -
Host D 192.168.33.4 -
The servers in the Server LAN have been assigned addresses of 172.22.242.17  172.22.242.30
The Finance Web Server is assigned an IP address of 172.22.242.23.
The Public Web Server is assigned an IP address of 172.22.242.17

A. Select to answer this question














 

Suggested Answer: A

Click the console PC and enter the following commands.
Corp1>enable -
Password: cisco -
We should create an access-list and apply it to the interface which is connected to the Server LAN because it can filter out traffic from both Sw-Hosts and
Core networks. The Server LAN network has been assigned addresses of 172.22.242.17 - 172.22.242.30 so we can guess the interface connected to them has an IP address of 172.22.242.30 (.30 is the number shown in the figure). Use the "show ipint brief" command to check which interface has the IP address of 172.22.242.30.
Corp1# show ip int brief -
Interface           IP-Address       OK?  Method   Status     Protocol
FastEthernet0/0     192.168.33.254   YES  manual   up         up
FastEthernet0/1     172.22.242.30    YES  manual   up         up
Serial0/0           198.18.196.65    YES  manual   up         up
We learn that interface FastEthernet0/1 is the interface connected to Server LAN network. It is the interface we will apply our access-list (for outbound direction)
Corp1# configure terminal -
Our access-list needs to allow host C - 192.168.33.3 to the Finance Web Server 172.22.242.23 via web (port 80)
Corp1(config)# access-list 100 permit tcp host 192.168.33.3 host 172.22.242.23 eq 80
Deny other hosts access to the Finance Web Server via web
Corp1(config)# access-list 100 deny tcp any host 172.22.242.23 eq 80
All other traffic is permitted -
Corp1(config)# access-list 100 permitip any any
Apply this access-list to Fa0/1 interface (outbound direction)
Corp1(config)# int fa0/1 -
Corp1(config-if)# ip access-group 100 out
Corp1(config-if)# end -
Notice:
We have to apply the access-list to Fa0/1 interface (not Fa0/0 interface) so that the access-list can filter traffic coming from the Core network.
Click on host C and open its web browser. In the address box type http://172.22.242.23 to check if you are allowed to access Finance Web Server or not. If your configuration is correct then you can access it.
Click on other hosts (A, B and D) and check to make sure you can't access Finance Web Server from these hosts.
Finally, save the configuration -
Corp1# copy run start -
Destination filename [startup-config]?
Building configuration...
[OK]
Corp1#

This question is in CCNA 200-125 exam 
For getting CCNA Certificate


Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.