Instructions: ✑ Enter IOS commands on the device to verify network operation and answer the multiple-choice questions. ✑ THIS TASK DOES NOT REQUIRE DEVICE CONFIGURATION. ✑ Click on R1 and R2 to gain access to the consoles of these devices. No console or enable passwords are required. ✑ To access the multiple-choice questions, click on the numbered boxes on the left of the top panel. ✑ There are four multiple-choice...

Questions › Category: 300-115 › Instructions: ✑ Enter IOS commands on the device to verify network operation and answer the multiple-choice questions. ✑ THIS TASK DOES NOT REQUIRE DEVICE CONFIGURATION. ✑ Click on R1 and R2 to gain access to the consoles of these devices. No console or enable passwords are required. ✑ To access the multiple-choice questions, click on the numbered boxes on the left of the top panel. ✑ There are four multiple-choice…

0 Vote Up Vote Down

Admin Staff asked 3 months ago

Instructions:
✑ Enter IOS commands on the device to verify network operation and answer the multiple-choice questions.
✑ THIS TASK DOES NOT REQUIRE DEVICE CONFIGURATION.
✑ Click on R1 and R2 to gain access to the consoles of these devices. No console or enable passwords are required.
✑ To access the multiple-choice questions, click on the numbered boxes on the left of the top panel.
✑ There are four multiple-choice questions with this task. Be sure to answer all four questions before selecting the Next button
Scenario:
Your customer has asked you to come in and verify the operation of routers R1 and R2 which are configured to use HSRP. They have questions about how these two devices will perform in the event of a device failure. Click on the devices or the tabs at the bottom of the screens to access the CLI to answer their questions.

What issue is causing Router R1 and R2 to both be displayed as the HSRP active router for group 2?

A. The HSRP group number mismatch

B. The HSRP group authentication is misconfigured

C. The HSRP Hello packets are blocked

D. The HSRP timers mismatch

E. The HSRP group priorities are different

Suggested Answer: B

Based on the configuration output, we see that authentication is configured on R2, but not on R1:
<img src="https://www.examtopics.com/assets/media/exam-media/01585/n44089800001.jpg" alt="Reference Image" />
<img src="https://www.examtopics.com/assets/media/exam-media/01585/n44089800002.jpg" alt="Reference Image" />
This can be further verified by issuing the "show standby" command on each router.
<img src="https://www.examtopics.com/assets/media/exam-media/01585/n44089800004.jpg" alt="Reference Image" />

This question is in 300-115 Implementing Cisco IP Switched Networks (SWITCH) Exam
For getting Cisco Certified Network Professional (CCNP) Routing and Switching Certificate

Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.
The website does not contain actual questions and answers from Cisco's Certification Exam.