Refer to exhibit. A network engineer is unable to make VRF lite EIGRP adjacency work. There is nothing wrong with communication between R1 and R2. What command will eliminate the issue when executed on both routers?

QuestionsCategory: 300-101Refer to exhibit. A network engineer is unable to make VRF lite EIGRP adjacency work. There is nothing wrong with communication between R1 and R2. What command will eliminate the issue when executed on both routers?
Admin Staff asked 3 months ago
Image
Refer to exhibit. A network engineer is unable to make VRF lite EIGRP adjacency work. There is nothing wrong with communication between R1 and R2. What command will eliminate the issue when executed on both routers?

A. (config-router-af)#network 209.165.202.128.0.0.0.31

B. (config)#ip multicast-routing

C. (config-router-af)#autonomous-system 100

D. (config-vrf)#route target both 100:1








 

Suggested Answer: C

To configure the autonomous-system number for EIGRP to run within a VPN routing and forwarding (VRF) instance, use the "autonomous-system" command in address-family configuration mode. In particular:
Router(config)# router eigrp 100
Router(config-router)# address-family ipv4 vrf Yellow
Router(config-router-af)# autonomous-system 100

This question is in 300-101 Cisco Implementing Cisco IP Routing (ROUTE) Exam
For getting Cisco Certified Network Professional (CCNP) Routing and Switching Certificate




Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.
The website does not contain actual questions and answers from Cisco's Certification Exam.

Recommended

Welcome Back!

Login to your account below

Create New Account!

Fill the forms below to register

Retrieve your password

Please enter your username or email address to reset your password.