Refer to exhibit.
 
The exhibit shows R1 topology table to reach 192.168.1.0/24 network. Which route(s) will be installed in routing table of R1 to reach network 192.168.1.0/24 after configuring R1 with the following command?
Router(config-router)# variance 2

A. R2 only

B. R2 and R3

C. R2 and R4

D. R2, R3 and R4








 

Suggested Answer: A

EIGRP will only use equal-cost load-balancing feature even when the variance command is used. However, if you use both the traffic-share min command and variance command, even though traffic is sent over the minimum-cost path only, all feasible routes get installed into the routing table, which decreases the convergence times

This question is in 300-101 Cisco Implementing Cisco IP Routing (ROUTE) Exam
For getting Cisco Certified Network Professional (CCNP) Routing and Switching Certificate




Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.
The website does not contain actual questions and answers from Cisco's Certification Exam.