Refer to the exhibit. A network engineer must configure an LDP neighborship between two newly installed routers that are located in two different offices. Router 1 is the core router in the network and it has already established OSPF adjacency with router 2. On router 1 and router 2. interface fa0/0 is configured for BFD. Which additional configuration must the engineer apply to the two devices to meet the requirement?

A. Router1(config)#int fa0/0 -Router1(config-if)#mpls ldp autoconfigRouter2(config)#router ospf 1 -Router2(config-router)#mpls ip

B. Router1(config)#int fa0/0 -Router1(config-if)#mpls ip -Router1(config-if)#mpls ldp discovery transport-address interfaceRouter2(config)#int fa0/0 -Router2(config-if)#mpls ip -Router2(config-if)#mpls ldp discovery transport-address interface

C. Route1(config)#int fa0/0 -Router1(config-if)#mpls ldp autoconfigRouter1(config-if)#mpls ldp discovery interfaceRouter2(config)#router ospf 1 -Router2(config-router)#mpls ldp autoconfigRouter2(config-if)#mpls ldp discovery interface

D. Router1(config)#int fa0/0 -Router1(config-if)#mpls ip -Router2(config)#router ospf 1 -Router2(config-router)#mpls ldp autoconfig








 

Suggested Answer: D



This question is in 350-501 SPCOR exam 
For getting CCNP Service Provider Certificate


Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.