Refer to the exhibit.
 
After configuring IS-IS on routers R1 and R2, an engineer notices that only the loopback interface at 2000:1::1 /96 is known to router R2. Which change must be made so that only Loopback2 is advertised from R1 to R2?

A. Configure the router isis area1 command under the Loopback0 interface on R1.

B. Remove the advertise passive-only command under the IS-IS address family ipv6 configuration

C. Remove the ipv6 router isis area1 command under the Loopback2 interface on R1.

D. Remove the passive-interface Loopback0 command under the router isis area1 configuration.








 

Suggested Answer: C



This question is in 300-510 Implementing Cisco Service Provider Advanced Routing Solutions (SPR) Exam
For getting Cisco Certified Network Professional Service Provider (CCNP Service Provider) Certificate



Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.
The website does not contain actual questions and answers from Cisco's Certification Exam.