Refer to the exhibit. An engineer deploys a Cisco MDS 9000 Series Switch in a SAN. N9K-1 fails to learn the target WWNs and the interface fc1/4 fails to operate. The engineer collected this information about the environment:
• MDS-A is configured as an NPV switch.
• The WWNs of the storage array are present in the FLOGI database of MDS-A.
• Interfaces fc1/3 and fc1/4 on MDS-A and N9K-1 are enabled.
Which set of actions resolves the issue?

A. Set 0x000001 FCID on N9K-1 and reset interface fc1/4.

B. On N9K-1, define fc1/4 as a trunk port and F port mode.

C. Configure F port on MDS-A fc1/3 and N9K-1 fc1/4.

D. Assign fc1/3 as NP port on MDS-A and F port on fc1/4 N9K-1.








 

Suggested Answer: A



This question is in 300-615 exam 
For getting CCNP Data Center Certificate


Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.