Refer to the exhibit. An engineer is troubleshooting an issue with traffic steering using the color-only automated steering mechanism. BGP is failing to automatically steer traffic into an SR policy with the given color of a route, regardless of the next hop. The Layer 2 configuration is correct, and the physical connection between the devices is working normally. Which additional command sequence must the engineer add to correct the issue?

A. Cisco(config)# segment-routing -Cisco(config-sr)# traffic-eng -Cisco(config-sr-te)# policy P1 -Cisco(config-sr-te-policy)# color 1 end-point ipv4 0.0.0.0

B. Cisco(config)# segment-routing traffic-engCisco(config-sr-te)# policy P1 -Cisco(config-sr-te-policy)# color 1 end-point ipv4 1.1.1.1Cisco(config-sr-te-policy )# autorouteCisco(config-sr-te-policy-autoroute)# include all

C. Cisco(config)# segment-routing -Cisco(config-sr)# traffic-eng -Cisco(config-sr-te)# policy P1 -Cisco(config-sr-te-policy)# color 1 end ipv4 1.1.1.1Cisco(config-sr-te-policy)# autoroute include all

D. Cisco# configure -Cisco(config)# segment-routing -Cisco(config-sr)# traffic-eng -Cisco(config-sr-te)# policy P1 -Cisco(config-sr-te-policy)# color 1 end-point








 

Suggested Answer: A



This question is in 300-510 Implementing Cisco Service Provider Advanced Routing Solutions (SPR) Exam
For getting Cisco Certified Network Professional Service Provider (CCNP Service Provider) Certificate



Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.
The website does not contain actual questions and answers from Cisco's Certification Exam.