Refer to the exhibit. An engineer must configure the interface that connects to PC1 and secure it in a way that only PC1 is allowed to use the port. No VLAN tagging can be used except for a voice VLAN. Which command sequence must be entered to configure the switch?

A. SW1(config-if)#switchport mode dynamic auto SW1(config-if)#switchport port-security SW1(config-if)#switchport port-security violation restrict

B. SW1(config-if)#switchport mode nonegotiate SW1(config-if)#switchport port-security SW1(config-if)#switchport port-security maximum 1

C. SW1(config-if)#switchport mode access SW1(config-if)#switchport port-security SW1(config-if)#switchport port-security mac-address 0050.7966.6800

D. SW1(config-if)#switchport mode dynamic desirable SW1(config-if)#switchport port-security mac-address 0050.7966.6800 SW1(config-if)#switchport port-security mac-address sticky








 

Suggested Answer: C

Community Answer: C



This question is in 200-301 Cisco Certified Network Associate (CCNA) Exam
For getting Cisco Certified Network Associate (CCNA) Certificate





Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.
The website does not contain actual questions and answers from Cisco's Certification Exam.