Refer to the exhibit. R1 and R2 are directly connected with Fast Ethernet interfaces and have the above configuration applied OSPF adjacency is not formed. When the debug ip ospf hello command is issued on R1, these log messages are seen: Which command can be configured on routers R1 and R2 on f0/0 interfaces to form OSPF adjacency?

Questions › Category: 350-501 › Refer to the exhibit. R1 and R2 are directly connected with Fast Ethernet interfaces and have the above configuration applied OSPF adjacency is not formed. When the debug ip ospf hello command is issued on R1, these log messages are seen: Which command can be configured on routers R1 and R2 on f0/0 interfaces to form OSPF adjacency?

0 Vote Up Vote Down

Admin Staff asked 4 months ago


Refer to the exhibit. R1 and R2 are directly connected with Fast Ethernet interfaces and have the above configuration applied OSPF adjacency is not formed.
When the debug ip ospf hello command is issued on R1, these log messages are seen:
 
Which command can be configured on routers R1 and R2 on f0/0 interfaces to form OSPF adjacency?

A. ip ospf network point-to-multipoint non-broadcast

B. ip ospf network non-broadcast

C. ip ospf network broadcast

D. ip ospf network point-to-point








 

Suggested Answer: D

Reference:
https://community.cisco.com/t5/routing/ospf-point-to-point-links/td-p/1913398

This question is in 350-501 SPCOR exam 
For getting CCNP Service Provider Certificate


Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.