Refer to the exhibit. Router 1 and router 2 are running OSPF Area 0. The router logs on both routers show that the LDP link has flapped. Which configuration must the engineer apply to the two routers to implement session protection on the link?

A. Router 1(config)# ip cef distributed Router 1(config)# mpls ldp session protection global Router 2(config)# ip cef distributed Router 2(config)# mpls ldp session protection global

B. Router 1(config)# ip cef distributed Router 1(config)# interface gigabitethernet 0/0 Router 1(config-if)# ip address 192.168.1.1 255.255.255.0 Router 1(config)# mpls ldp session protection Router 2(config)# interface gigabitethernet 0/0 Router 2(config-if)# ip address 192.168.1.2 255.255.255.0 Router 2(config)# mpls ldp session protection

C. Router 1(config)# ip cef distributed Router 1(config)# interface gigabitethernet 0/0 Router 1(config-if)# ip address 192.168.1.1 255.255.255.255 Router 1(config-if)# exit Router 1(config)# mpls ldp session protection Router 2(config)# ip cef distributed Router 2(config)# interface gigabitethernet 0/0 Router 2(config-if)# ip address 192.168.1.2 255.255.255.255 Router 2(config-if)# exit Router 2(config)# mpls ldp session protection

D. Router 1(config)# ip cef distributed Router 1(config)# interface gigabitethernet 0/0 Router 1(config-if)# ip address 192.168.1.1 255.255.255.0 Router 1(config-if)# mpls label protocol ldp Router 1(config-if)# mpls ip Router 1(config-if)# exit Router 1(config)# mpls ldp session protection Router 2(config)# ip cef distributed Router 2(config)# interface gigabitethernet 0/0 Router 2(config-if)# ip address 192.168.1.2 255.255.255.0 Router 2(config-if)# mpls label protocol ldp Router 2(config-if)# mpls ip Router 2(config-if)# exit Router 2(config)# mpls ldp session protection








 

Suggested Answer: D



This question is in 350-501 SPCOR exam 
For getting CCNP Service Provider Certificate


Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.