Refer to the exhibit. SW2 is replaced because of a hardware failure. A network engineer starts to configure SW2 by copying the fa0/1 interface configuration from SW1. Which command must be configured on the fa0/1 interface of SW2 to enable PC1 to connect to PC2?

A. switchport mode trunk

B. switchport trunk native vlan 10

C. switchport mode access

D. switchport trunk allowed remove 10








 

Suggested Answer: A

Community Answer: A



This question is in 200-301 Cisco Certified Network Associate (CCNA) Exam
For getting Cisco Certified Network Associate (CCNA) Certificate





Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.
The website does not contain actual questions and answers from Cisco's Certification Exam.