Refer to the exhibit. Switch port FastEthernet 0/24 on AlSwitch1 will be used to create an IEEE 802.1Q-complaint trunk to another switch. Based on the output shown. What is the reason the trunk does not form, even though the proper cabling has been attached?

QuestionsCategory: 200-125Refer to the exhibit. Switch port FastEthernet 0/24 on AlSwitch1 will be used to create an IEEE 802.1Q-complaint trunk to another switch. Based on the output shown. What is the reason the trunk does not form, even though the proper cabling has been attached?
Admin Staff asked 6 months ago
Refer to the exhibit.
 Image
Switch port FastEthernet 0/24 on AlSwitch1 will be used to create an IEEE 802.1Q-complaint trunk to another switch. Based on the output shown. What is the reason the trunk does not form, even though the proper cabling has been attached?

A. VLANs have not been created yet.

B. An IP address must be configured for the port.

C. The port is currently configured for access mode.

D. The correct encapsulation type has not been configured.

E. The no shutdown command has not been entered for the port.






 

Suggested Answer: C



This question is in CCNA 200-125 exam 
For getting CCNA Certificate


Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.

Next Post

Recommended

Welcome Back!

Login to your account below

Create New Account!

Fill the forms below to register

Retrieve your password

Please enter your username or email address to reset your password.