Refer to the exhibit. Which configuration must be added to R2 to enable PC3 to obtain a DHCP address and successfully ping PC1?

Questions › Category: 350-401 › Refer to the exhibit.

Which configuration must be added to R2 to enable PC3 to obtain a DHCP address and successfully ping PC1?

Admin Staff asked 10 months ago

Refer to the exhibit.

Which configuration must be added to R2 to enable PC3 to obtain a DHCP address and successfully ping PC1?

A. Router(config)# vrf definition PRODUCTION
Router(config-vrf)# address-family ipv4
Router(config)# interface GigabitEthernet 0/0
Router(config-if)# vrf forwarding PRODUCTION
Router(config-if)# ip address 10.199.0.1 255.255.252.0
Router(config)# ip dhcp pool R&D
Router(dhcp-config)# vrf PRODUCTION

B. Router(config)# vrf definition PRODUCTION
Router(config-vrf)# rd 1:100 -
Router(config)# router eigrp 100
Router(config-rtr)# redistribute vrf PRODUCTION

C. Router(config)# vrf definition PRODUCTION
Router(config-vrf)# vnet tag 100
Router(config)# interface GigabitEthernet 0/0
Router(config-if)# vnet trunk -

D. Router(config)# vrf definition PRODUCTION
Router(config-vrf)# rd 1:100 -
Router(config-vrf)# address-family ipv4
Router(config)# router eigrp 100
Router(config-rtr)# route-target export 1:100










Correct Answer: A

This question is in 350-401 Implementing Cisco Enterprise Network Core Technologies (ENCOR) Exam exam
For getting CCNP Enterprise Certificate

Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.
The website does not contain actual questions and answers from Cisco's Certification Exam.