Refer to the exhibit. Which feature set must be used to configure on switch 2 to establish a VSAN trunk between switch 1 and switch 2?
A.
✑ F Port
✑ Trunk Mode Passive
B.
✑ N Port
✑ Trunk Mode Active
C.
✑ NP Port
✑ Trunk Mode Auto
D.
✑ E Port
✑ Trunk Mode On
















 

Suggested Answer: D

By default, trunk mode is enabled in all Fibre Channel interfaces. However, trunk mode configuration takes effect only in E-port mode. You can configure trunk mode as on (enabled), off (disabled), or auto (automatic). The default trunk mode is on. The trunk mode configuration at the two ends of an ISL, between two switches, determine the trunking state of the link and the port modes at both ends (see Table 15-1).
 
Reference:
https://www.cisco.com/en/US/docs/storage/san_switches/mds9000/sw/rel_3_x/configuration/guides/cli_3_2/trnk.html

This question is in 350-601 DCCOR exam 
For getting CCNP Data Center Certificate


Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.