Which configuration feature should be used to block rogue router advertisements instead of using the IPv6 Router Advertisement Guard feature? A. VACL blocking broadcast frames from nonauthorized hosts B. PVLANs with promiscuous ports associated to route advertisements and isolated ports for nodes C. PVLANs with community ports associated to route advertisements and isolated ports for nodes D. IPv4 ACL blocking route advertisements from nonauthorized hosts Correct Answer: B This question is in 300-410 exam For getting CCNP Enterprise Certificate
Please login or Register to submit your answer
Refer to the exhibit. Which two actions restrict access to router R1 by SSH? (Choose two.)
Refer to the exhibit. A network is configured for EIGRP equal-cost load balancing, but the traffic destined to the servers is not load balanced. Link metrics from router R2 to R3 and R4 are the same. Which delay value must be configured to resolve the issue?
Refer to the exhibit. Why is the remote NetFlow server failing to receive the NetFlow data?
Refer to the exhibit. The network administrator configured the network to connect two disjointed networks and all the connectivity is up except the virtual link, which causes area 250 to be unreachable.
Which two configurations resolve this issue? (Choose two.)
Refer to the exhibit. Which action resolves intermittent connectivity observed with the SNMP trap rackets?
Refer to the exhibit. An engineer recently implemented uRPF by configuring the ip verify unicast source reachable-via rx command on interface gi0/3. The engineer noticed right after implementing uRPF that an inbound packet on the gi0/3 interface with a source address of 172.16.3.251 was dropped. Which action resolves the issue?
