Which two methods of deployment can you use when implementing NAT64? (Choose two.)

A. stateless

B. stateful

C. manual

D. automatic

E. static

F. functional

G. dynamic


 

Suggested Answer: AB

While stateful and stateless NAT64 perform the task of translating IPv4 packets into IPv6 packets and vice versa, there are important differences. The following table provides a high-level overview of the most relevant differences.
Table 2. Differences Between Stateless NAT64 and Stateful NAT64 Stateless NAT64
Stateful NAT64 -
1:1 translation
1:N translation
No conservation of IPv4 address -
Conserves IPv4 address -
Assures end-to-end address transparency and scalability Uses address overloading, hence lacks in end-to-end address transparency No state or bindings created on the translation
State or bindings are created on every unique translation Requires IPv4-translatable IPv6 addresses assignment (mandatory requirement) No requirement on the nature of IPv6 address assignment Requires either manual or DHCPv6 based address assignment for IPv6 hosts Free to choose any mode of IPv6 address assignment viz. Manual, DHCPv6, SLAAC Reference: http://www.cisco.com/c/en/us/products/collateral/ios-nx-os-software/enterprise-ipv6-
 solution/ white_paper_c11-676277.html

This question is in 300-101 Cisco Implementing Cisco IP Routing (ROUTE) Exam
For getting Cisco Certified Network Professional (CCNP) Routing and Switching Certificate




Disclaimers:
The website is not related to, affiliated with, endorsed or authorized by Cisco.
Trademarks, certification & product names are used for reference only and belong to Cisco.
The website does not contain actual questions and answers from Cisco's Certification Exam.